Sub-Zero SZ-CR2 - Page 3

SZ-CR2 2
Index
Parameter
Description
Page No.
Minimum ON/OFF time between two Compressors.
17
Time interval at which the Set Point for Compressors will
get interchanged.
17
Set Point Interchange on Fault.
18
Activate/deactivate HP Fault Digital Input for Compressor1.
18
Compressor1 HP Fault Digital Input sensing delay.
18
Reset mode for Compressor1 output, on Compressor1 HP
Fault Digital Input.
18-19
No. of retrials of Compressor1 HP Fault Digital Input.
19
Activate/deactivate Compressor1 LP Fault Digital Input.
19
Compressor1 LP Fault Digital Input Sensing Delay. (Surge)
19
Compressor1 LP Fault Digital Input Sensing Delay. (Normal)
20
Reset mode for Compressor1 output, on Compressor1 LP
Fault Digital Input.
20
No. of retrials of Compressor1 LP Fault Digital Input.
20
Activate/deactivate Compressor1 SPP Fault Digital Input.
21
Activate/deactivate Compressor2 HP Fault Digital Input.
21
Compressor2 HP Fault Digital Input sensing delay.
21
Reset mode for Compressor2 output, on Compressor2 HP
Fault Digital Input.
22
No of retrials of Compressor2 HP Fault Digital Input.
22
To activate/deactivate Compressor2 LP Fault Digital Input.
23
Compressor2 LP Fault Digital Input Sensing Delay. (Surge)
23
Compressor2 LP Fault Digital Input Sensing Delay. (Normal)
23
Reset mode for Compressor2 output, on Compressor2 LP
Fault Digital Input.
23-24
No of retrials of Compressor2 LP Fault Digital Input.
24
Activate/deactivate Compressor2 SPP Fault Digital Input.
24
Time delay to switch OFF the Light.
24
Enable/Disable Light Relay ON at Door Open.
25
Clear Compressor1 Run Hours.
25
Clear Compressor2 Run Hours.
25
Clear Fault Log
25
Display during Defrost.
26
Default (Normal) Display.
26
Display Delay.
26
Activate Alarm Relay.
26
Ht or Lt Alarm Power ON Delay.
27
Time Delay to activate Alarm Relay at Door Open.
27