Sub-Zero SZ-CR2 - Page 31

SZ-CR2 30
Note:
• This parameter is not considered if CS = C2 and
P71 = 0.
Function: Balanced defrost frequency for Compressor
2.
Example: If P82 is set to 6Hr, then b82 will show the
remaining Defrost cycle frequency time for
Compressor2. i.e. b82 = P82 - P82 hours over.
Note:
• This parameter is not considered if CS = C1 and
P72 = 0.
Min.
Max.
Fac.
0 Hr
31 Hr
-
Function: Last 10 fault logs.
This parameter shows last 10 fault logs one by one
with respective fault code.
Min.
Max.
Fac.
-
-
Function: End of Programming.
To end ‘Run Hour and Fault Logs’ Mode.