WIRING: The probe and its corresponding wires should never be installed in a conduit next to control
or power supply lines. The electrical wiring should be done as shown in the diagram. The power supply
circuit should be connected to a protection switch. The terminals admit wires of upto 2.5sq mm.
WARNING: Improper wiring may cause irreparable damage and personal injury. Kindly ensure that
wiring is done by qualified personnel only.
Maintenance: Cleaning: Clean the surface of the controller with a soft moist cloth. Do not use abrasive
detergents, petrol, alcohol or solvents.
Notice: The information in this document is subject to change in order to improve reliability, design
or function without prior notice and does not represent a commitment on the part of the company.
In no event will the company be liable for direct, indirect, special, incidental or consequential damage
arising out of the use or inability to use the product or documentation, even if advised of the
possibility of such damages. No part of this manual may be reproduced or transmitted in any form or
by any means without the prior written permission of the company.
Controller: Controller should be installed in a place protected by vibration, water and corrosive gasses
and where ambient Temperature does not exceed the values specified in the technical data.
Probe: To give a correct reading, the probe must be installed in a place protected from thermal
influences, which may affect the Temperature to be controlled.
Disclaimer: These manual & its contents remain the sole property of PVR CONTROLS, India and shall
not be reproduced or distributed without authorization. Although great care has been taken in the
preparation of this document, the company or its vendors in no event will be liable for direct, indirect,
special, incidental or consequential damage arising out of the use or inability to use the product or
documentation, even if advised of the possibility of such damages. No part of this manual may be
reproduced or transmitted in any form or by any means without the prior written permission of the
company. PVR CONTROLS, reserves the right to make and changes or improvements without prior
notice.
Warranty: This product is warranted against defects in materials and workmanship for a period of
one year from the date of purchase. During the warranty period, product determined by us to be
defective in form or function will be repaired or, at our option, replaced at no charge. This warranty
does not apply if the product has been damaged by accident, abuse, and misuse or as a result of
service or modification other than by the company. This warranty is in lieu of any other warranty
expressed or implied. In no event shall the company be held liable for incidental or consequential
damages, including lost revenue or lost business opportunity arising from the purchase of this
product.
To Next Page
Loading...