- 76 -
Reference
Sound quality does not change even after
making adjustments.
The adjusted audio quality is not included in the radio
broadcast or disc.
Check by changing the radio station or disc.
A CD/DVD will not go into the deck. Power is not turned on. Turn the vehicle ignition switch to [ACC] or [ON].
A disc is already inserted and you are trying to insert a
second disc.
Eject the previously inserted CD/DVD and insert the
preferred CD/DVD.
A CD/DVD cannot be played. There is water condensation inside the equipment. Stop using the equipment for a short time and then try
using it again. (See page 9)
There is a large scratch or warp in the CD/DVD. Insert a different CD/DVD.
The CD/DVD is very dirty. Clean the CD/DVD. (See page 9)
The CD/DVD is upside down. Insert the CD/DVD with the proper orientation.
A non-supported type of CD/DVD has been inserted. Insert a CD/DVD that is supported in the deck. (See
page 9)
Audio is output, but not video. The screen has been turned off with the screen OFF
button.
Press the [SCREEN AV/NAV] button. (See page 15)
Audio is output, but not DVD video.
(With vehicle stopped.)
The emergency / parking brake has not been set. Set the emergency / parking brake.
Neither video nor audio is output. The vehicle ignition switch has not been turned on. Turn the vehicle ignition switch to [ACC] or [ON].
The connection wires and cables are not completely
connected.
Check the connections to each connection wire and
cable.
There is a point of light on the display. At least 99.99% of the pixels on the PND-display are
effective, but it is possible that 0.01% of the pixels may not
light or may stay lighted.
This is not a defect, so please use the equipment in this
condition.
Phenomenon Possible cause Action
To Next Page
Loading...
Need help?
General
