To Next PageTo Next Page
Need help?Do you have a question about the Subaru H631SFJ000 and is the answer not in the manual?
General| Brand | Subaru |
|---|---|
| Model | H631SFJ000 |
| Category | Car Speakers |
| Language | English |
Prepare the vehicle by parking, engaging the brake, lowering windows, and disconnecting the battery.
Use screwdrivers to open screw covers and remove screws from the front door panel.
Pry the front door panel from the bottom corner to release clips.
Lift the front door panel upwards to detach it from the door.
Unclip door lock and handle cables from the back of the door panel.
Carefully remove electrical connectors from the door panel.
Disconnect the speaker harness and remove the old speaker with screws.
Attach the new speaker wire to the clip on the speaker, towards the car's front.
Install the new Kicker speaker and secure it with the provided screws.
Connect the wiring harness and wrap the connector with foam tape to prevent rattles.
Reassemble the front door panel by reversing the removal steps.
Use a slotted screwdriver to open screw covers on the rear door panel.
Pry the rear door panel from the bottom rear corner to release clips.
Pull out and lift the rear door panel to detach it from the door.
Unclip door lock and handle cables from the back of the rear door panel.
Unclip the wire harness from the rear door panel and set the panel aside.
Remove the screws and detach the old rear speaker.
Disconnect the speaker harness from the existing rear speaker.
Connect the wiring harness to the new Kicker speaker and install it.
Reassemble the rear door panel by reversing the removal steps.
Reconnect the vehicle's battery after completing the speaker installation.
