ABS-22
ABS (DIAGNOSTICS)
CLEAR MEMORY MODE
9. Clear Memory Mode
A: OPERATION
1. WITHOUT SUBARU SELECT MONITOR
1) After calling up a trouble code, disconnect diag-
nosis connector terminal 6 from diagnosis terminal.
2) Repeat 3 times within approx. 12 seconds; connecting and disconnecting terminal 6 and diagnosis termi-
nal for at least 0.2 seconds each time.
NOTE:
After diagnostics is completed, make sure to clear memory. Make sure only start code (11) is shown after
memory is cleared.
2. WITH SUBARU SELECT MONITOR
Refer to SUBARU SELECT MONITOR for information about how to clear trouble codes. <Ref. to ABS-18,
Subaru Select Monitor.>
B4M0231E
B4M0233G
To Next Page
Loading...
