Subaru Legacy 2003 - Inspection Mode

VDC-22
VDC (DIAGNOSTICS)
SUBARU SELECT MONITOR
3. CLEAR MEMORY MODE
1) On the «Main Menu» display screen, select {2.
Each System Check} and press the «YES» key.
2) On the «System Select Menu» display screen,
select {Brake System} and press the «YES» key.
3) Press the «YES» key after the engine type is dis-
played.
4) On the «Brake Control Diagnosis» display
screen, select {Clear Memory} and press the
«YES» key.
5) When `Done' and `turn ignition switch OFF' are
shown on the display screen, turn the Subaru Se-
lect Monitor and ignition switch to OFF.
NOTE:
For detailed operation procedure, refer to the SUB-
ARU SELECT MONITOR OPERATION MANUAL.
4. FUNCTION CHECK
Display screen Contents to be monitored Index No.
ABS sequence control mode
Perform ABS sequence control by operating
valve and pump motor sequentially.
<Ref. to VDC-16, ABS Sequence Control.>
VDC check mode
Perform VDC sequence control by operating
valve and pump motor sequentially.
<Ref. to VDC-19, VDC Sequence Control.>
Set mode St. r. A. Sen. N &
Lat. G Sen. Op
Set both the neutral position of the steering
angle sensor and the zero “0” point of the lateral
G sensor.
<Ref. to VDC-26, Steering Angle Sensor.>