106
Vehicle Dynamics and Driver Assist Systems
May 2017
Service
Vehicle Dynamics Control (VDC/VSC) Centering Mode
After installing, replacing, or adjusting the following components, it is necessary to perform the
VSC(VDC) Centering Mode. This mode is performed by placing the vehicle on a level surface
with the steering wheel in the straight ahead position.
• Steering Angle Sensor
• Steering Wheel
• Suspension Components
• Wheel Alignment
• VDCCM & H/U
• VDCCM & H/U Bracket
After the VSC (VDC) Centering Mode has been completed, test drive the vehicle for at least 10
minutes to ensure there are no system malfunctions.
VSC (VDC) Centering Mode
3-106
To Next Page
Loading...
