Subaru Legacy 2010 - Pre-Collision Brake off Switch; Lane Departure Warning off Switch

116
Vehicle Dynamics and Driver Assist Systems
May 2017
The EyeSight
®
system contains two switches to control the ON and OFF functions of the
Pre-Collision Braking and Lane Departure Warning systems. Depending on the model, these
switches may be located on the Stereo Camera cover or the left driver’s console.
Pre-Collision Brake OFF Switch
Press and hold the Pre-Collision Brake OFF switch to turn off the Pre-Collision Braking
System and the Pre-Collision Throttle Management. When these systems are off, the
indicator light on the instrument panel illuminates. Press and hold the button again to
turn the systems back on. In the following situations, turn off the Pre-Collision Braking
System otherwise the Pre-Collision Braking System may activate unexpectedly.
- When the vehicle is being towed
- When loading the vehicle onto a carrier
- When a chassis dynamometer, free-rollers or similar equipment is used
- When a mechanic lifts up the vehicle, starts the engine and spins the wheels freely
- When passing hanging banners, flags or branches, or when thick/tall vegetation is
contacting the vehicle
- When using a drive-through car wash
Lane Departure Warning OFF Switch
Press and hold the Lane Departure warning OFF switch to turn off the Lane Departure
Warning and the Lane Sway Warning functions. When these functions are off, the
indicator light on the instrument panel illuminates. Press and hold the button again to
turn the functions back on.
Pre-collision brake
OFF switch
Lane departure
warning OFF switch
Camera Mounted Switches
EyeSight
®
OFF Buttons LDW and PCB OFF Switches
4-6
4-7 4-8