154
Vehicle Dynamics and Driver Assist Systems
May 2017
Service and Diagnostics
Stereo Camera Care and Handling
The Stereo Camera lenses are precision components and require great care in handling.
When the system detects that the Stereo Camera lenses are dirty, EyeSight
®
functions will be
prohibited. Always observe the following precautions when handling them:
• Do not touch or try to clean the EyeSight
®
camera lenses inside the vehicle. Extra
precaution should be used when cleaning the inside of the windshield. Over-spray from
cleaners may impair or even damage the camera lenses.
• Do not remove or disassemble the stereo cameras or lenses.
• Do not change the positions where the Stereo Cameras are installed or modify any of
the surrounding structures.
• Do not install any interior rearview mirror other than a genuine SUBARU rearview
mirror (such as a wide-type mirror). Also, use the rearview mirror so it does not obstruct
the Stereo Camera assembly. Failure to do so may affect the field of vision and could
prevent the EyeSight
®
system from functioning properly.
Stereo Camera Warning Label Use of Protection
The Stereo Camera lens hoods can be inspected for contamination through the windshield
glass. Thin and uniform accumulation of dust, dirt, or tobacco stains resulting from normal
use should not cause issues. Do not attempt to clean or service in these cases. In the event a
Stereo Camera lens hood becomes contaminated, it is possible to replace the hoods separately
from the camera assembly. Once the lens hoods have been replaced, the Camera Adjustment,
Inspection procedure must be performed.
Lens Hood Inspection Lens Hood Removed
4-93 4-94
4-95
4-96
To Next Page
Loading...
