199
Vehicle Dynamics and Driver Assist Systems
May 2017
Service
Removal of a sonar sensor is accomplished by depressing the lock tabs on the top and bottom
of the assembly in order to release the claws. Care should be taken so as to not damage the
lock release tabs on the Sensor Holder/bezel or harness connector.
Caution: Always disconnect the ground cable from the battery before attempting service on
the RAB system.
Sonar Sensor Removal
When removing the harness cord from the sensor assembly, use a flat tip screwdriver wrapped
with a protective covering such as tape. Failing to do so may cause cosmetic damage to the
sensor body.
Harness Cord connection Harness Cord Removal
5-52
5-53
5-54
To Next Page
Loading...
