Tighten screws (⑤) to complete assembly of the floater .
(as shown above)
Insert screws (③) (no need to tighten but only insert); (as shown above)
Press the floater down toward SUBLUE Mix to make the suction cups on
the floater (④) attach to the SUBLUE Mix; (as shown below)
Align the hanger of the floater(①) with the hanger of the SUBLUE Mix
body (②); (as shown below)
Installation of the floater. (optional)
-11- -12-
Check whether the product shell is damaged. If yes, do not use it;
Press the two start buttons in the air (no more than one minute) for
testing. Ensure the thrusters and indicators are in good condition without
jamming or noise;
In order to prevent loss, an safety leash is provided during deep diving. Pay
attention to the surroundings to prevent entanglement;
After above inspection, it can be put into use. In case of any problem,
please stop using immediately.
Before use, fully charge the battery with a dedicated charger. If all the five
Indicators are on, the battery is full;
If the battery is secured correctly, buckling sound can be heard;
(as shown in the following diagram)
Preparations before usage
Operating Instructions
Install The
Battery
Before Installation After Installation
Giving Off
Buckling Sound
To Next Page
Loading...
