8 13
WHEN USING ELECTRICAL PRODUCTS, ESPECIALLY WHEN CHILDREN ARE PRESENT,
BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE
FOLLOWING:
DANGER --- READ ALL INSTRUCTIONS BEFORE USING
TO REDUCE THE RISK OF ELECTRICAL SHOCK:
Always unplug the device from the electrical outlet immediately after using
and before cleaning.
DO NOT reach for a device that has fallen into water. Unplug it
immediately.
WARNING --- TO REDUCE THE RISK OF BURNS, ELECTRIC SHOCK, FIRE OR
INJURY TO PERSONS:
A device should never be left unattended when plugged in. Unplug from
outlet when not in use and before putting on or taking off parts or
attachments.
Close supervision is necessary when this device is used by, on or near
children, invalids or disabled persons.
Use this appliance only for its intended use as described in this manual.
Do not use attachments not recommended by StudioFeed USA Ltd;
specifically any attachments not provided with the unit.
NEVER operate this device if it has a damaged cord or plug, is not working
properly, has been dropped or damaged or submerged in water. Please
Return it to the SUBPAC® service center for examination and repair (see
Warranty attached for details).
Keep cord away from heated surfaces.
NEVER drop or insert any object into any opening.
DO NOT operate where aerosol (spray) products are being used or where
oxygen is being administered.
DO NOT operate under a blanket or pillow. Excessive heating could occur
causing fire, electrocution or personal injury.
DO NOT carry this device by the power cord or use the power cord as a
handle.
To disconnect, turn the power setting OFF, then remove the plug from the
outlet.
CAUTION – PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING.
This product is not intended for any medical use.
Using Your SubPac
®
M2
The SUBPAC® transmits low and sub-bass frequencies directly into your
body. The combination of the vibrations from the SUBPAC® and the
frequencies that you hear via headphones/monitors create a full-range
immersive experience. After a short while acclimatising to this new
experience, you will be able to combine what is felt and what is heard into
a deep and meaningful listening experience.
Cables:
Connect your listening device/output source to the line-in port on the
control box using the supplied 3.5mm audio cable.
Plug your headphones into the headphone jack on the control box.
Adjust the volume from the audio source to a comfortable listening level.
Slowly adjust the intensity knob on the control box to your personal taste.
See tips for optimal settings.
Bluetooth Pairing:
For Bluetooth pairing, unplug the audio cable and hold down the power
button for 4 seconds to make your SUBPAC® M2 visible to devices, the
Bluetooth LED will turn solid blue. Search for ‘SUBPAC® M2’ in your
transmitting device’s Bluetooth settings and pair with it as per the
manufacturer’s recommendations. When successfully paired the LED will
flash until audio is played, where it will turn solid again.
Strapping and Attachment
The SUBPAC® M2 is designed to fit tightly on your body. The more physical
contact the unit has on your back, the better the experience will be. The
SUBPAC® M2 has been ergonomically designed to fit the contours of your
back naturally.
The cover is water-resistant but not waterproof. Do not immerse in water!
The SUBPAC® M2 can be cleaned with a damp cloth and a mild detergent.
Do not attempt to remove the electronics of the unit without consulting
SUBPAC® customer service first.
To Next Page
Loading...