Kickplate Installation
O
nce the unit is leveled and wiring connections made, the
kickplate can be installed. Use the two #10 x 1/2" stain-
less steel screws that are provided with the kickplate.
Refer to the illustration below.
IMPORTANT NOTE: The kickplate must be removed for
servicing. The floor cannot interfere with removal. The
louvered section of the kickplate must not be covered so
as to prevent air circulation.
Turn power back on to the electrical outlet.
Door Panel—Model 424
M
odel 424 is offered in two design applications; stainless
steel (/S) and overlay (/O). Each of these designs are avail-
able as a glass door (G) model.
The stainless steel model 424/S is available as a glass
door (G) model only, with the classic finish and is shipped
from the factory with the decorative stainless steel door
panel and matching handle in place.
The overlay model 424/O is available as a glass door (G)
or solid door (S) model and is designed to accept a
decorative door panel to match surrounding cabinetry.
The door panel and the handle will be provided by the
customer.
Before beginning installation, check for the correct com-
ponents for the fit and finish desired. All overlay doors
require a decorative panel 23
3
/4" (603) by 30
1
/16" (764) and
a minimum
5
/8" (16) thick.
IMPORTANT NOTE: For installations at or above 5,000'
(1524 m) in altitude, a special high altitude glass door unit
(HA) must be ordered.
If you have questions, contact your Sub-Zero dealer or
cabinet supplier. Additional panel information can be
found in the Sub-Zero design guide.
Models 424 and 424FS Installation 10
Kickplate installation.
A solid panel must not be installed on a glass door
unit, as this may cause moisture to form behind the
panel.
To Next Page
Loading...
