Models 427 and 427R Installation 19
subzero.com
Leveling
L
evel the unit by turning the front leveling legs clockwise
to raise the unit, or counterclockwise to lower it. To assist
you in adjusting the front leveling legs up or down, use a
standard screwdriver blade and place it in the front
leveling leg as shown in the illustration below.
The rear leveling legs are adjusted from the front of the
base by turning the Phillips head screw. Refer to the illus-
tration below.
IMPORTANT NOTE: The rear leveling legs will only move
1
/16" (2) for every 18 revolutions on the Phillips head screw.
Do not over torque. Use the lowest torque setting on any
power screwdriver. Do not turn the rear leveling legs by
hand. Damage will occur if you turn these legs.
Install Molding
T
he decorative white molding strips for the top and sides
of models 427 and 427R can be snapped into place as
shown in the illustrations below. The top molding piece
must be installed before the side molding can be
attached. For installations where units are positioned side
by side, refer to side panels on page 25.
Front leveling leg adjustment. Rear leveling leg adjustment.
To reduce the possibility of the unit tipping forward,
the front leveling legs must be in contact with the
floor.
Top molding installation.
Side molding installation.
To Next Page
Loading...
