EasyManua.ls Logo

Sullair 1600H T4F Perkins - Help; Troubleshooting a Non-Responsive Touchscreen; Resetting a Non-Responsive Touchscreen

Sullair 1600H T4F Perkins
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1600H T4F Perkins User Manual 6: Controller
02250248-733 R03
Subject to EAR, ECCN EAR99 and related export control restrictions. 59
6.5 Help
Help menu is accessed via the physical HELP button on
the front of the controller or the HELP soft key in the main
menu. This menu contains a QR code which when
scanned will take the user to the product manuals. Addi-
tionally, there is a soft key for an operational guide and
brief troubleshooting section.
6.5.1 Troubleshooting a non-responsive
touchscreen
If the touchscreen of the STS Controller stops respond-
ing when touched, but is still showing parameters in real
time and the operator can still use the five physical but-
tons below the controller and the OFF/ON/START switch,
the touchscreen is "frozen" or "locked up" and needs to
be reset.
6.5.1.1 Resetting a non-responsive
touchscreen
1. Toggle the OFF/ON/START switch to the
OFF position to shut down the compressor.
2. Wait until the engine has stopped running for
at least 120 seconds and pressure has
dropped to 3 psi.
3. Switch the battery disconnect to the OFF
position.
The battery disconnect is located near the
batteries on the upper-right side (see Fig-
ure 2-1 on page 24).
4. Wait 30 seconds.
5. Switch the battery disconnect to the ON
position.
6. Restart the compressor.
Figure 6-8: Help display

Table of Contents

Related product manuals