1100E, 1500E, 1800E USER MANUAL SECTION 6
52
6.5 FLUID FILTER
MAINTENANCE
Refer to Figure 6-1. Replace your fluid filter element
under any of the following conditions, whichever
occurs first:
1. As indicated by the WS Controller.
2. Every fluid change.
F
LUID FILTER ELEMENT REPLACEMENT
Refer to Figure 6-1.
1. Using a wrench, remove the filter canister.
2. Remove and dispose of filter element.
Observe all laws and regulations for filter dis-
posal.
3. Clean gasket seating surface.
4. Apply a light film of fluid to the element seal.
5. Install the element into the filter canister.
6. Screw the canister to the filter head. Tighten
to 10 to 12 ft·lb. (13.5 to 16.0 N·m)
7. Restart compressor and check for leaks.
6.6 AIR FILTER MAINTENANCE
Refer to Figure 6-2. Air filter maintenance should be
performed when the maintenance gauge shows red
with the compressor running full load, or once a year,
whichever comes first. If the filter needs to be
replaced, order a replacement element. Below you
will find procedures on how to replace the air filter
element.
A
IR FILTER ELEMENT REPLACEMENT
1. Pull the yellow latch to release the cover.
2. Clean exterior of air filter housing.
3. Rotate end cover counterclockwise and
remove
4. Remove air filter element by pulling it out of
the housing.
5. Clean interior of housing using a damp cloth.
DO NOT blow dirt out with compressed air.
6. At this time replace the element.
7. Reassemble in the reverse order of the dis-
assembly.
Figure 6-1: Fluid Filter Assembly
1. Filter Head
2. Element*
3. Body
Fluid Filter: 02250156-599
*Fluid Filter Repair Kit: 02250156-601
Figure 6-2: Air Filter Assembly
1. Housing
2. Clamp
3. Element*
4. Cover
Air Filter: 02250125-370
*Replacement Element: 02250125-365
To Next Page
Loading...
