107
375 John Deere Standard and Aftercooled/Filtered Operator’s Manual and Parts List
ILLUSTRATIONS AND PARTS LIST
7.7a CONTROL PARTS & DISCHARGE PARTS - 300HH, 375H, 375HH AND 425H
CE (EUROPEAN) MODELS (CONTINUED)
Key Description Part Number Note Quantity
40 connector, tube-male 5/16 x 1/4 812205-025 1
41 nut, hex f pltd 5/16-18 825305-283 4
42 capscrew, hex gr8 1/2-13 x 1 3/4 828208-175 4
43 capscrew, hex gr5 5/8-11 x 1 3/4 829110-175 8
44 screw, hex ser washer 5/16-18 x 3/4 829705-075 4
45 screw, hex ser washer 3/8-16 x 1/2 829706-050 2
46 washer, pl-b reg unn 5/16 837205-071 8
47 washer, pl-b reg unn 1/2 837208-112 4
48 washer, spr lock 1/2 837508-125 4
49 washer, pl-b reg pltd 3/8 838206-071 2
50 elbow, 37 90m 1 1/2 x 1 1/2 860224-150 1
51 nipple, pipe-xs plt 1 1/2 x cl 866424-000 1
52 nipple, pipe-xs plt 1 1/2 x 6 866424-060 1
53 elbow, pipe 45 deg 300# plt 1 1/2” 869430-060 1
54 conn, 90d str x jic 1 5/16 x 1 5/16 870616-016 1
A Shown 3/8” OD tubing blue
B To start run valve (end tee) 3/8 OD tubing red
C To unit oil return port 1/4” OD tubing white
D To start run valve (side) port 3/8” OD tubing orange
E To inlet valve 3/8” OD tubing yellow
G To inlet valve hose 5/16” OD white
H To unit (below inlet valve) 1/4” black
(I) Replacement 0-ring part number 826502-232.
(II) See Section 7.10
(III) See Section 7.9
(IV) For color variations, see table in Section 7.20
To Next Page
Loading...
