81
375 John Deere Standard and Aftercooled/Filtered Operator’s Manual and Parts List
ILLUSTRATIONS AND PARTS LIST
7.3 ENGINE, COMPRESSOR AND PARTS (CONTINUED)
Key Description Part Number Note Quantity
1 bushing, taperlock 2012 02250049-415 (III) 1
2 valve, drain eng oil 19mm x 1.50 02250051-231 1
3 key, shaft step 375h 02250053-263 1
4 elbow, check valve 1/4t x 1/8p 02250058-275 1
5 elbow, 90 3/8" tube x 1/4"npt m 02250099-626 (I) 1
6 washer, snubbing vibration mount 02250125-471 4
7 mount, vibration isolator 375 02250125-473 4
8 support, engine front l&r jd 02250125-478 2
9 washer, snubbing 375 vibration mount 02250125-604 2
10 switch, engine oil pressure n.o. 02250130-668 1
11 spacer, fan 375dpq-jd4045tf 02250133-599 1
12 clamp, t-bolt ss band 2 1/4"id 02250137-795 4
13 hose, rad upper 375-425 jd t2 02250138-188 1
14 hose, rad lower 375-425 jd t2 02250138-189 1
15 elbow, silicone cac 2" id x 45 deg 02250138-197 1
16 elbow, cac pipe 2"id x 90 deg 02250138-198 1
17 switch, engine hi-temp 225f nc 1/2npt 02250138-450 1
18 clamp, 2"id high temp 02250140-362 2
19 coupling, assembly ringfedder ac-t4.1 02250146-634 (IV) 1
20 adapter, red 1/2-14 npt murphy thrd 02250155-384 1
21 tube, cac hot 375 jd t3 02250164-527 1
22 tube, cac cold sd 375 jd t3 02250164-528 1
23 fan, cooling 26" 375 jd t3 02250164-543 1
24 sub assembly, control orice 375h jd t3 02250168-182 (II) 1
25 guard, belt alt 375 ca t3 ce 02250172-939 1
26 guard, belt upper lh 375 ca t3 ce 02250172-941 1
27 guard, belt lower 375 ca t3 ce 02250172-942 1
28 clamp, hose 1 5/16" to 2 1/4" adj. 040014 2
29 clamp, hose 1 13/16" x 2 3/4" adj. 040083 2
30 gasket, 1/32 x 5 1/4odx4 1/8id 040708 1
31 clamp, hose 1/2" 043197 1
32 tube, ss 1/4" fuel return 250011-577 1
33 connector, 1/4t x 1/4 npt str 250018-428 1
34 adapter, eng-compr 375 jd 250022-732 1
35 spacer, coupling 375 jd & cat 250023-218 (III) 1
36 key, shaft 375 250023-340 1
37 valve, air inlet 4" 375 dpq 250026-779 1
38 coupling assy 375 jd & cat 250031-586 (III) 1
39 bushing, taper-loc 2517 1.93id 407848 (IV) 1
40 clamp, hose 1-1/8" i.d. - 408300-007 1
41 clamp, hose 1 13/16" i.d. - 408300-009 1
42 nut, hex f pltd 1/4-20 825304-236 1
43 nut, hex f pltd 5/16-18 825305-283 1
44 nut, hex locking 5/8-11 825510-329 2
45 capscrew, hex 8.8 m10 x 35mm 828010-035 12
To Next Page
Loading...
