Section 1
5
DHL HEATLESS REGENERATIVE DRYER
INTRODUCTION
Thank you for choosing our product. In order to get
the best performances from this product, please read
this manual carefully. To avoid damage to the
equipment and physical risk to the operator, please
read and strictly follow the instructions contained in
this manual. Note, these instructions are in addition
to the Local and Federal safety rules that apply
where the dryer is installed.
Before packing for shipment eachDHL series
heatless adsorption air dryer is subjected to rigorous
testing to demonstrate that the device can perform
all the functions for which it has been designed.
Once the dryer has been properly installed according
to the instructions in this manual, it will be ready for
use without any further adjustment. The operation is
fully automatic, and the maintenance must be
performed regularly, as detailed in the following
chapters.
This manual should be kept available for future
reference and is intended to be an important tool
in the proper operation and maintenance of the
dryer.
Due to the continuous technical evolution, we
reserve the right to introduce any necessary change
without giving previous notice.
Should you experience any trouble, or for further
information, please do not hesitate to contact us.
1.1 IDENTIFICATION PLATE
The product identification plate shows all the primary
data of the machine. Upon installation, fill in the table
shown on the side copying the data shown on the
identification plate. Refer to this datawhen ordering
parts or requesting service, even during the warranty
period.
Removal or alteration of the identification plate will
void the warranty
1.2 WARRANTY CONDITIONS
For 12 months from the installation date, but no
longer than 18 months from the delivery date, the
warranty covers eventual faulty parts, which will be
repaired or replaced free of charge.
The warranty doesn’t cover any responsibility for
direct or indirect damages to persons, animals or
equipment caused by improper usage or
maintenance, and it’s limited to manufacturing faults
only.
Model
Serial No.
Code Heatless Regenerative Dryer
Nominal Flow Rate SCFM
Max. Air Pressure 150 PSIG
Max. Inlet Air
Temperature
100°F
Ambient
Temperature
100°F
Dessicant
(type and Qty)
Activated Alumina
Electric Supply
115/110/1/50,60 208/220/1/
50,60
Electric Nominal
Power
10W
Fuse Max. 1 AMP
Manufactured —
To Next Page
Loading...
