Section 11
ILLUSTRATIONS AND PARTS LIST
111
11.17 CONTROL BOX- LS-200 AND VCC-200 SUPERVISOR CONTROLLER
key part
number description number quantity
1 fuse, kldr (I) -2
2 heater, o.l. pack (I) -1
3 starter, 3ph 120v chf open (I) -1
4 starter, man mtr prot - 1
5 block, contact chf lrg aux 1 no 02250048-396 1
6 gasket, panel Supervisor II 02250048-822 1
7 panel, cover Supervisor II 02250054-854 1
8 block, aux contac 1no-1nc mot/prot 02250057-765 1
9 gasket, ctl pnl Supervisor II 02250071-093 1
10 grip, cord n4 .125-.187 x 1/2” 02250071-379 2
11 grip, cord n4 .250-.375 x 1/2” 02250071-381 5
12 switch, vacuum 22”wc n4 6ft cable 5a 02250078-249 1
13 transducer, pressure 0-250 psi 1-5vdc n4 02250078-933 4
14 nameplate, E-stop 45mm yellow 02250081-473 1
15 transformer, control 250va univ w/pri fh 02250083-188 1
16 switch, push-button operator e22 40m 02250085-504 1
17 specification, encl ls-12/16 30w x 10d x 36lg 02250099-482 1
18 bar, ground 5 post cutler hammer 02250101-721 1
19 control, Supervisor III display mod 02250119-330 1
20 control, Supervisor III io mod 02250119-331 1
21 support, bracket xdcr/press sw 02250129-880 1
22 decal, Supervisor front 02250130-344 1
23 panel, instrument Supervisor 02250134-463 1
24 transformer, control 50va 120-24 50/60 02250135-283 1
25 support, control panel 02250136-227 1
26 bracket, control panel 02250136-474 1
27 connector, cord .312 cable x 1/2” hu 241585 2
28 switch, pressure n.o. 10 psi 250017-992 1
29 fuse, limitron ktk-r 2.00 250019-756 1
30 contactor, ac 3p 18v 120v chf 250025-703 1
31 block, contact 1nc 250027-125 1
(I) This part may vary per machine design. Consult factory with machine serial number to determine the
proper part number.
PLEASE NOTE: WHEN ORDERING PARTS, INDICATE THE SERIAL NUMBER OF COMPRESSOR
Continued on page 113
To Next Page
Loading...
