17
NOTES
2.6 DRYER OPERATION
PROCEDURE
1. Starting of a Single phase dryer for the first
time
a. Make sure all air connections are intact and
have no leaks
b. Double check wiring connections
c. Set the rocker switch to “I”
2. Daily starting and shut-down
a. Push on the green button to start the dryer.
b. The start light will indicate that the dryer is
running.
3. To stop the dryer, first stop the airflow (either
shut-down the air compressor or close the
inlet/outlet or by-pass valve). When the air
flow is stopped, push the green button to the
stop position.
NOTE
1. Avoid turning OFF the dryer when com-
pressed air is still flowing through it.
2. To switch the already preheated dryer
on again, simply push the green start
button.
To Next Page
Loading...