SECTION 2 SHOPTEK
™
CONTROLLER USER INTERFACE MANUAL
15
02250180-094 R00
SUBSEQUENT START-UP PROCEDURE
1. On subsequent start-ups, check the fluid
sight glass for proper fluid level. Service if
necessary. See compressor User’s Manual.
2. Press the START pad on the display
screen. The machine will prepare to start up
in the last operating mode existing at shut-
down. The current Machine mode will
appear on the display screen.
3. If a different operating mode is desired, use
the arrow pads to navigate to the Load Mode
parameter. Press the pad to change
the mode. Navigate to the desired mode
(Automatic or Manual). Press the pad
to accept and save the mode setting.
4. When the compressor is running, observe
the display panel and maintenance indica-
tors to ensure the values displayed are
within the proper ranges.
2.4 SHUTDOWN PROCEDURE
Shut down the compressor by pressing the STOP
pad on the Controller panel.
S
NOTE
The system may require a set amount of
time to pass prior to restarting.
WARNING
The compressor may restart automatically
after a power failure or after the E-Stop but-
ton has been reset.
To Next Page
Loading...
