02250236-267 R02 Subject to EAR, ECCN EAR99 and related export control restrictions.
Maintenance and Inspection (continued)
22
Component
Inspection
Instructions
Maintenance and Inspection Time Interval
Remarks
Daily
Every
500 Hours
or 2 Months
Every
2,500 Hours
or 1 Year
Every
5,000 Hours
or 2 Years
Every
10,000Hours
or 4 Years
Every
15,000Hours
or 6 Years
Every
20,000Hours
or 8 Years
Air Receiver
Tank (Option)
Drain accumulated
condensate in air receiver.
○
Complete Air
Compressor
Remove accumlation of dust
and/or dirt.
○
Inspect for excessive noise
and vibration.
○ Refer to page 25.
Safety Relief
Valve
Inspect operation. ○
Replace the safety
relief valve if there is
any damage.
Pressure Sensor
Inspect operation and confirm
valid pressure displayed.
○
Replace the sensor if
there is any damage.
Check Valve Inspect for leaks or replace. ○ ●
Ventilating Fan
Inspect or replace
the ventilating fan.
○ ● Refer to page 26.
Bolts, Nuts &
Screws
Inspect and tighten any
loose items.
○ Refer to page 26.
Intake Air Filter
Replace a dirty or
clogged filter.
○ ● ◎ Refer to page 26.
Sirocco Fan &
Scroll Fin
Clean the dirt off
these components.
○ ◎
Scroll Bearing
Grease or inspect
the bearing.
○ ◎
Replace the scroll head if
there is any damage with
bearing.
Tip Seal & Face
Seal
Replace the seals. ● ◎
Bearings Inspect the bearings. ○ ◎
Replace the scroll head if
there is any damage with
bearings.
Scroll Head
Replace the scroll
head.
●
Rubber Hose Inspect for leaks. ○ ●
Replace the rubber
hose if there is any
damage.
V-Belts
Inspect, adjust and/or replace
a loose or damaged v-belt
○ ● Refer to page 27.
Electromagnetic
Contactor
Inspect or replace. ○ ●
Rubber Vibration
Isolator Pads
Inspect for any damage
and/or hardness.
○
Replace the pads if
there is any damage.
Electric Main
Motor
Inspect for any damage. ○
Replace the motor if
there is any damage.
Coolers
Clean the dirt off or
replace.
○ ●
【145PSIG Model】
※ ○ represents the periodic inspection period during operation or after parts have been replaced and a ● represents the
parts replacement period.
※ ◎ represents parts that should be replaced at the same time as the scroll head replacement.
※ Operation time on the control panel digital display is the total running hours of the SRL air compressor.
※ The maintenance and service time intervals shown are for normal operation. The inspection period may differ slightly
for different operating conditions, such as high temperature and/or humidity. If the operating conditions are severe and/or
unsatisfactory, reduce the inspection time intervals.
※ Carry out the maintenance and inspections based on the recommended total operating hours and/or calendar time in the
maintenance schedule, whichever occurs first.
※ It is recommended to request maintenance and inspection from the local Sullair distributor for any items in the shaded
area ( ).
To Next Page
Loading...
