Section 11
ILLUSTRATIONS AND PARTS LIST
119
11.19 CONTROL BOX- ELECTRO-MECHANICAL
key part
number description number quantity
1 fuse, kldr (I) -2
2 heater, o.l. pack (I) -1
3 starter, 3ph 120v chf open (I) -1
4 starter, man mtr prot (I) -1
5 block, contact chf lrg aux 1 no 02250048-396 1
6 block, aux contac 1no-1nc mot/prot 02250057-765 1
7 locknut, n4 conduit sealing 02250071-362 8
8 locknut, cond seal n4 1” 02250071-365 2
9 transformer, control 250va univ w/pri fh 02250083-188 1
10 switch, high temperature 240 deg f - 3/4” sae 02250100-095 2
11 bar, ground 5 post cutler hammer 02250101-721 1
12 support, bracket xdcr/press sw 02250129-880 1
13 support, control panel 02250136-227 1
14 bracket, control panel 02250136-474 1
15 sub assembly, ctlpnl emd ls20 02250136-851 1
16 switch, pres 0-150# spdt n-1 040694 1
17 coupling, conduit rigid 250007-179 2
18 switch, pressure n.o. 10 psi 250017-992 1
19 elbow, 1/4” tube x 1/4” npt 250018-430 1
20 fuse, limitron ktk-r 2.00 250019-756 1
21 contactor, ac 3p 18v 120v chf 250025-703 1
22 block, terminal kt3 250041-102 16
23 block, term adapter kad 250041-103 1
24 plug, hole n4 1/2” cond 409918-002 5
25 nut, hex pltd #10-24 825202-130 2
26 nut, hex f pltd 5/16-18 825305-283 4
27 nut, hex f pltd 3/8-16 825306-347 4
28 screw, hex ser washer 5/16-18 x 3/4 829705-075 4
29 screw, hex ser washer 3/8-16 x 1 829706-100 4
30 screw, mach-rd hd #10-24 x 1/2 831602-050 2
31 washer, spr lock reg pltd #10 837802-047 2
32 conduit, csa flex 1/2” 846315-050 6
(I) This part may vary per machine design. Consult factory with machine serial number to determine the
proper part number.
PLEASE NOTE: WHEN ORDERING PARTS, INDICATE THE SERIAL NUMBER OF COMPRESSOR
Continued on page 121
To Next Page
Loading...
