Section 7
ILLUSTRATIONS AND PARTS LIST
45
7.4 COMPRESSOR, FRAME AND DRIVE - 200HP/ 150KW
key part
number description number quantity
1 orifice, .040” x .25m x .25m nptf 02250109-215 1
2 motor, (I) -1
3 drawing, tube&ftg-d321165d vac w/pu (II) 02250126-462 1
4 hub, coupling 2.375 bore falk 30r 02250152-635 1
5 hub, coupling 2.75 bore falk 30r 02250152-638 1
6 element, cplg falk 30r 02250152-671 1
7 cover, cplg element falk 30r 02250152-679 1
8 guard, coupling vs25/32 falk cplg 02250160-343 1
9 orifice, .062” x .25m x .25m nptf 027443 1
10 probe, thermistor for 46869 046867 1
11 strainer, v-type 300psix1/4 (III) 241771 1
12 lug, lifting 25 series 250008-361 4
13 elbow, 90deg m swvl 1/4t x 1/4 npt 250025-850 2
14 connector, male1/4tube x 1/4 250025-859 2
15 frame, base rsvs32-200 250039-529 1
16 support, motor rsvs32-200 250039-530 2
17 elbow, tube 90 deg m 5/16 x 1/4 810505-025 1
18 nut, hex pltd 1/2-13 825208-448 16
(I) Drive motor part number will vary based on horsepower and voltage variation.
(II) There is an exchange program whereby a remanufactured vacuum unit can be obtained from Sullair
representatives or the factory at less cost than the owner could repair the unit. For information
regarding the unit exchange program, contact your nearest Sullair representative or the Sullair
Corporation.
The shaft seal is not considered part of the vacuum unit in regard to the 2 year warranty. The normal
Sullair parts warranty applies.
(III) For maintenance on strainer no. 241771, order repair kit no. 241772.
PLEASE NOTE: WHEN ORDERING PARTS, ALWAYS INDICATE SERIAL NUMBER OF VACUUM
Continued on page 47
LEGEND
A FROM CLOSED INLET CYLINDER (RELIEF PORT)
B FROM SULLICON CONTROL TEE (ONE PORT PLUGGED)
C INTERNAL TO CONTROLS
D FROM SCAVENGER RETURN LINES
To Next Page
Loading...