Section 3
SPECIFICATIONS
25
Figure 3-3A Piping and Instrumentation - VS-16 30-40HP/ 22-30KW Air-cooled
key description part number quantity
number
1 vacuum guage 250042-041 2
2 inlet filter 250024-659 1
3 vacuum switch 02250164-176 1
4 inlet check valve 250028-224 1
5 butterfly valve 040640 1
6 filter, vacuum regulator 250009-221 1
7 vacuum regulating valve 250023-600 1
8 sullicon control 02250081-075 1
9 orifice .062” 027443 1
10 rotary screw vacuum pump (I) - 1
11 temperature gauge 02250100-096 1
12 thermistor probe 046867 1
13 separator tank 02250148-329 1
14 separator element 02250048-713 1
15 rupture disk 250024-890 1
16 fluid level sight glass 02250097-611 2
17 fluid drain check valve/w plug 02250151-414 1
18 genisis filter assembly 02250117-782 1
19 sight glass/orifice block sae 02250126-129 1
20 orifice, plug brass .062” 02250125-775 1
21 orifice .062” 040127 1
22 separator diff. pressure gauge 250003-798 1
23 high discharge pressure switch 250025-975 1
24 pump suction strainer 02250149-931 1
25 manifold block 02250149-930 1
26 pressure regulating valve 02250127-388 1
27 thermal valve assembly 02250150-915 1
28 thermal valve element 049542 1
29 heat exchanger 02250142-507 1
30 fluid filter sae 250025-519 1
31 fluid filter diff. pressure gauge 250003-799 1
32 fluid pressure gauge 250024-662 1
33 low fluid pressure switch 250017-992 1
34 orifice .125” 250016-495 1
35 pressure regulating valve 250024-654 1
36 solenoid valve - n.o. (II) 02250125-538 1
37 inlet diff. pressure switch (III) 250032-907 1
38 separator diff. pressure switch (III) 02250050-154 1
(I) Part varies by model. Consult the factory with machine serial number to determine correct part num-
ber.
(II) Used with dual control option.
(III) Used with annunciation option.
Continued on page 27
To Next Page
Loading...