Section 3
SPECIFICATIONS
37
Figure 3-3D Piping and Instrumentation - VS-16 50HP/ 37KW Water-cooled
key part
number description number quantity
1 vacuum guage 250042-041 2
2 inlet filter 250024-659 1
3 vacuum switch 02250164-176 1
4 inlet check valve 250028-224 1
5 butterfly valve 040640 1
6 filter, vacuum regulator 250009-221 1
7 vacuum regulating valve 250023-600 1
8 sullicon control 02250081-075 1
9 orifice.062" 027443 1
10 rotary screw vacuum pump (I) -1
11 temperature gauge 02250100-096 1
12 thermistor probe 046867 1
13 separator tank 02250148-331 1
14 separator element primary 250034-123 1
15 separator element secondary 250034-129 1
16 rupture disk 250024-890 1
17 fluid level sightglass 02250097-611 2
18 fluid drain check valve/wplug 02250151-414 1
19 genisis filter assembly 02250117-782 2
20 sightglass/orifice block sae 02250126-129 2
21 orifice, plugbrass.093"primary 02250125-776 1
22 orifice, plugbrass.062"secondary 02250125-775 1
23 orifice .062" 040127 1
24 separator diff. pressure gauge 250003-798 1
25 high discharge pressure switch 250025-975 1
26 pump suction strainer 02250149-931 1
27 manifold block 02250149-930 1
28 pressure regulating valve 02250127-388 1
29 thermal valve assembly 02250150-915 1
30 thermal valve element 049542 1
31 heat exchanger 02250110-238 1
32 fluid filter sae 250025-519 1
33 fluid filter diff. pressure gauge 250003-799 1
34 fluid pressure gauge 250024-662 1
35 low fluid presss w/ water press sw 250017-992 2
36 orifice .125" 250016-495 1
37 pressure regulating valve 250024-654 1
38 valve, globe (II) 040520 1
39 valve, water reg (III) 047398 1
(I) Part varies by model. Consult the factory with machine serial number to determine correct part num-
ber.
(II) Used with water regulating hand valve option.
(III) Used with water regulating Penn valve option.
Continued on page 39
To Next Page
Loading...