Install the bottom bracket with the M5 bolts and washers, you can use power tools to assist in
this step.
After the bottom bracket is installed, you will now need to add thread locker to your terminals (if
using drilled terminals)
Setting Up Electronics & Cell wiring:
This step involves wiring up your cells, you will need a BMS system and optionally a
supplementary balancing device to complete this step. You will also need to have the
appropriate wiring done to complete the electrical setup. If you are using our SFK-150 4s Bms,
all wiring and prep has been done for you and simply requires you to screw in your components.
Page: 6 V1 / V2 Manual - Revision 1.01
To Next Page
Loading...