Need help?Do you have a question about the Sun Tap Water Systems WS1 and is the answer not in the manual?
General| Brand | Sun Tap Water Systems |
|---|---|
| Model | WS1 |
| Category | Water Dispenser |
| Language | English |
Hard water flows through resin, removing minerals and iron. Resin capacity depends on resin amount and salt dosage.
System displays alternate between current time and days/gallons remaining before regeneration.
The words 'REGEN TODAY' appear on display if a regeneration is scheduled for that day.
Keep valve body and cover free of dirt and debris. No lubrication is required.
Major cleaning recommended every two years. Follow detailed steps for emptying, cleaning, and refilling.
Maintain adequate salt (6-8") or potassium (12") level. Use pellet salt; do not overfill if usage is low.
Clean resin annually or as needed to maintain effectiveness, especially if iron is present in water.
System memory retains settings for up to two hours. Longer outages require time-of-day reset.
Step-by-step guide to set the current hour and minutes using control buttons, typically after power outages.
How to start regeneration before the scheduled time, either for a specific time or immediately via the REGEN button.
Contact dealer for 'ERROR' codes; code 1003 indicates general control valve malfunction.
Do not use Vaseline, oils, or silicone spray. Use Teflon tape on NPT threads; avoid pipe dope.
Connect to supply line, install shutoff valve, and attach fittings before securing nuts/rings to avoid heat damage.
Ensure drain capacity, proper fitting placement, and use appropriate tubing or pipe for backwash flow.
Install an overflow line to a drain to prevent damage from potential brine overflows.
Crucial: Maintain air gap between drain line and wastewater to prevent back-siphoning into the conditioner.
Use the provided test kit to check the water softness.
Check salt level; add salt if low. Clean the brine tank if dirty.
To Next Page