Sunbeam 2587 - FILTER REPLACEMENT; Filter Replacement Procedure

FILTER REPLACEMENT
1. As always, unplug unit prior to opening grill.
2. Open and remove inlet grill by depressing latches of bottom or right side of grill (depending on
orientation) and pulling away from air cleaner until hooks near outlet grill come Iree.
3. Check the appearance of the prefilter to see if there is a visible amount of dust or lint. If so, simply
soak the prefilter in warm soapy water and completely dry before replacing in the unit.
4. Check the HEPA filter cartridge to see which condition it matches on the filter indicator located on
the housing of the unit near the outlet grill.
If the filter is brown in color, then it is time to change to a new filter,
Remove the
HEPA filter and
replace it with a new Sunbeam
HEPA filter, Model 6613.
This fitter also comes with a new
foam
prefilter:
Do not attempt to wash the HEPA filter,
5. Under normal conditions the
HEPA filter should last 9-12 months. Frequent cleaning of the
pre-filter will help extend the life of the
HEPA filter.
6. The replacement
HEPA filter and pre-filter, Model 6613 can be purchased from your local supplier.
In U.S. call 1-800-597-5978 and in Canada call l-800-66-SUNBEAM for the supplier nearest you.
Dirty filter indicator
Outlet grill
\
I
ON/OFF/FAN
speed switch
Pre-filter