Sunbeam 3016 - Operating Your Classic Iron; Fill Water Reservoir; Dry Ironing; Steam Ironing

TO FI l l T h E WA T E R RE S E R v O I R (use tap water)
1.Makesuretheironisunplugged.SettheSteamLeverto
(Dry)andtheFabricSelecttoOFF.
2.LifttheWaterFillHoleCover.
3.Fillwatercupwithtapwater.Pourwaterintoironwaterreservoir.Donotfillwaterreservoirbeyondmaximum
filllevel.
WARNING:Topreventtheriskofburns,becarefulwhenfillingahotironwithwater.Hotmetalparts,hotwater
andsteamcancauseinjuries.
DR y IR O N I N G
1.MakesuretheSteamLeveristurnedtothe (Dry)setting.
2.Plugthecordintoa120-VoltACoutlet.
3.Selectthefabricsettingyoudesire(Silk or Synthetics).Allowtheirontoheatfor2minutes.
Whiletheironisheating,makesureitissittingonitsheelrestonastable,protectedsurface.
Note:WhiletheSteamLeveristurnedtothe
(Dry)setting,youmaystillusetheSHOTOFSTEAM
®
orSPRAY
MIST
®
feature.Pleasemakesurethewaterreservoirisapproximately¼fullofwater.
ST E A M IR O N I N G
1.Followtheinstructionsfor“FillingtheWaterReservoir.”
2.Plugthecordintoa120-VoltACoutlet.
3.Selectthefabricsettingyoudesire(Synthetic, Silk, Linen, Cotton or Wool).Allowtheirontoheatfor2minutes.
Whiletheironisheating,makesureitissittingonitsheelrestonastable,protectedsurface.
4.Allowtheirontoheatfor2minutes,andthenturntheSteamLevertotheappropriatesetting.
IMPORTANT: Whennotironing,alwayssettheSteamLeverto
(Dry)andtheFabricSelecttoOFF.
US I N G T h E IR O N ’S SP E c I A l FE A T U R E S
SP R A y MI S T
®
FE A T U R E isapowerfulwaterspraymistthatdampensthefabrictoaidinremovingwrinklesfrom
heavyfabricsandforsettingcreases.
To use the Spray Mist
®
Feature:PresstheSPRAYMIST
®
buttonfirmly.
S
h O T O F ST E A M
®
FE A T U R E (select models only)providesanextraburstofsteamfordeeppenetrationofstubbornwrinkles.
YoucanusethisfeaturewhileDryorSteamironing.Thewaterreservoirmustbeapproximately¼fullofwater.
To use the Shot of Steam
®
Feature:Placetheironontopofthewrinkleandpressthe SHOTOFSTEAM
®
button
eachtimeyouwouldlikeanextraburstofsteam.The SHOTOFSTEAM
®
featuremaybeusedcontinuouslywith
justashortpausebetweenshots.
WARNING:Topreventtheriskofburns,keepyourhandawayfromtheareabeingsteamed.
WARNING:DONOTsteamgarmentswhilewearingthem;thismayresultininjuries.
MO T I O N SM A R T
®
AU T O -OF F FE A T U R E
Whentheironispluggedin,thePowerIndicatorwilllightsteadily,indicatingthatthereispowertotheiron.
If you leave the iron:
1.inahorizontalpositionwithoutmovingit,oraccidentallytiptheironover,itwillautomaticallystopheating
after30seconds.ThePowerIndicatorwillblinktoletyouknowthattheironhasstoppedheating.
2.inaverticalposition(onitsheelrest)withoutmovingit,theironwillautomaticallyturnoffafter15minutes.
ThePowerIndicatorwillblinktoletyouknowthattheironhasstoppedheating.
IMPORTANT:ThePowerIndicatorwillcontinuetoblinkuntiltheironisunpluggedorreset.
To reset the iron:
Movetheironbackandforthandallowittoreheatfor2minutes.Theindicatorwillstopblinkingandtheiron
willstartheatingagain.
WARNING:ThepatentedMOTIONSMART
®
Auto-Offisasafetyfeature,notarecommendedmeansforturning
yourironoff.See“CaringforYourIronAfterUse”forinformationonturningoffyourironandstoringitsafely
betweenuse.
ST O R A G E ST R I P
®
IN D I c A T O R isaneasywaytoseewhentheironiscoolenoughtostore.
To use the Storage Strip
®
Indicator: Turnironon.Inapproximately2minutes,theSTORAGESTRIP
®
Indicator
English-3