EasyManua.ls Logo

Sunbeam EM0700 - Page 12

Sunbeam EM0700
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
Advanced Settings
Recalibration of the EM0700
To recalibrate for a coarser grind
6. Takenoteofyourcurrentgrindsetting
position.
7. Rotatethegrindadjustmentcollarto
position15onthegrindsettings,see
figure12.
8. Lifttherecalibrationreleaseleverand
removegrindadjustmentcollar,seefigure
13and14.
9.Tomakethegrindcoarser,repositionthe
collartosetting10onthegrindsettings.
10.Re-assemblethecollarbypressingdown
thefrontandthentherearensuringtwo
clicksareheard.
11.Returnthegrindsettingbacktoyour
originalgrindsettingposition.Yourgrind
willnowbecoarser.
12.Attachthehopper,openthehopper
closurearmandturnonthegrinder.
Note:Checkthenewsettingdeliversthe
requiredgrindbeforeuse.
To recalibrate for a finer grind
Note:Thegrinderisfactorysetforfine
grinding.Onlyre-calibratefinerifthe0
settingdoesnotachievethedesiredgrind
fineness.
6. Rotatethegrindadjustmentcollarto
position15onthegrindsettings,
seefigure12.
7. Lifttherecalibrationreleaseleverand
removegrindadjustmentcollar,seefigure
13and14
8. Tomakethegrindfiner,repositionthe
collartosetting17onthegrindsettings.
9.Re-assemblethecollarbypressingdown
thefrontandthentherearensuringtwo
clicksareheard.
10.Attachthehopperandrunthegrinderto
ensuresmoothoperation.
Caution:Re-calibratingtoofinemaycause
burrstocollideresultinginametallic
grindingnoise.Ifthisoccursturnoffthe
grinderandmovetoacoarsersetting(a
settingtowards30)orre-calibratefora
coarsergrind.
11.Openhopperclosurearmandadjust
grindsettingstodeliverrequiredgrind
size.
Note:Furthertuningmayberequired.
Note:Recalibrationwillchangeallprevioussettingsonthegrinder
1. Closehopperclosurearm.
2. Purgebeansthroughthegrinder.
3. Turntheoperationdialtothe‘off’position.
4. Disconnecttheplugfromthepowersocket.
5. Removethebeanhopperbyturninganticlockwise.

Related product manuals