skybar
™
Wine Opener
How to use the wine opener
Removing the cork:
1. Place the wine bottle on a flat surface.
2. With one hand holding the wine bottle steady, place the pin in
the center of the cork and push the pin straight down through
the cork until the Retainer Ring is pushed all the way up to the
top of the pin per figure 2.
3. Now, while holding the wine bottle with one hand, raise the
Main Body up to furthest point and push back down until it
stops per figure 3.
4. Repeat this pumping motion several times and the cork
should pop out per figure 4.
Note: This manual pump Wine Opener works in that it forces
air into the bottle of wine and will force the cork out as air
fills the internal part of the bottle. DO NOT squeeze the lower
body when using the Wine Opener
5. To remove the cork from the Skybar Wine Opener, hold the
Main Body with one hand and push the Retainer Ring away to
remove cork from pin per figure 4.
Fig. 2 Fig. 3 Fig. 4
skybarhome.com | 1 888 skybar9skybarhome.com | 1 888 skybar9
To Next Page
