GROWLIGHT GARDEN
PARTS INCLUDED
2 x 24” SunBlaster T5HO Strip Light
2 x 24” NanoTech Reectors
1 x Curved Canopy - holds lights
1 x Reservoir and self watering
platform
2 x Aluminum square tubes
1 x Wicking Mat
2 x Plastic plugs for aluminum tubes
2 x Height Adjusters
4 x Growing Trays Long
1 x T-Power Cord with on/off switch
4 x Fixing Bolts
4 x Nuts
4 x Ballast Clips
1 x Owner’s Manual
GROWLIGHT GARDEN - MICRO
PARTS INCLUDED
1 x 12” SunBlaster T5HO Strip Light
1 x 12” NanoTech Reector
1 x Curved Canopy - holds lights
2 x Reservoir and self watering
platforms
2 x Aluminum square tubes
1 x Wicking Mat
2 x Plastic plugs for aluminum tubes
2 x Height Adjusters
4 x Growing Trays Short
1 x Power Cord with on/off switch
2 x Fixing Bolts
2 x Nuts
2 x Ballast Clips
1 x Owner’s Manual
PLEASE NOTE: The Micro Growlight Garden features a single T5HO Strip Light, while
the Growlight Garden features two T5HO Strip Lights.
WICKING - HOW IT WORKS
Place your growing trays on top of the watering platform. The
wicking mat will naturally absorb and draw water across the
length of the watering platform. The water reaches the roots
of your plants through the holes in the bottom of your growing
trays. This ensures optimal water distribution and no worry of
over watering, as your plants will only soak up as much water as
they require. The base is your reservoir, ll part way and check to
maintain a good supply of water for your plants.
LIGHT ADJUSTMENT - HOW IT WORKS
Once your garden is assembled, use the
height adjustment collars to support the
canopy at the desired height above your
growing medium. You may have to start
with the canopy quite close to the plants
and then move up gradually as the plants
begin to develop. Do not overtighten.
Steel Black Nut
Height
Adjuster
Clamp
Thumbscrew
Fig. 4
Canopy
Plastic Plug
Flat Base Tray
Aluminium
Tu be
Height Adjuster
Clamp
Steel Black Nu
Height
Adjuster
Clamp
Thumbscrew
Fig. 4
Canopy
Plastic Plug
Flat Base Tray
Aluminium
Height Adjuster
Tube
Clamp
To Next Page
Loading...