Need help?Do you have a question about the SUNFUNG SF-C350 and is the answer not in the manual?
Steps for unboxing and initial setup of the SF-C350 cutter.
Final step of the machine assembly process.
Explanation of various touch icons and their functions on the machine's panel.
Icons for controlling carriage and roller movement (Left, Right, Forward, Backward).
Icons for rebooting the machine and performing test cuts.
How to perform a test cut to check and adjust knife pressure.
Adjusting the machine's cutting speed and knife pressure.
Overview of the main settings menu options.
How to set up the machine for different material types.
Adjusting the camera's fill light for better material recognition.
Viewing the machine's cutting history and statistics.
Correcting contour deviations and fine-tuning alignment.
Displaying the camera's field of view for diagnostics.
Configuring the machine's network IP address and port.
Selecting the display language for the machine interface.
Accessing the machine's debugging interface for advanced diagnostics.
Accessing internal machine settings, requires a password.
Setting the machine's size ratio for accurate cutting.
Configuring operational limits for the machine's movements.
Adjusting camera parameters for optimal scanning and recognition.
Testing the camera's position relative to the cutter holder.
Adjusting the camera's fill light for better material recognition.
Viewing and setting specific camera offset values.
Automatically updating light source values for current materials.
Setting contour deviation values for precise cutting.
Selecting the machine's edge scanning mode (e.g., Normal, Simple).
Setting the area the machine scans for edge detection.
Choosing the cutting mode (e.g., Cutter, Die cutting).
Adjusting the display screen brightness.
Setting the paper feeding speed.
Selecting the USB port mode (e.g., Virtual COM, Printer).
Testing the continuous paper feeding function.
Restoring the machine to its default factory settings.
Performing an aging test on the machine.
Setting paper retraction method after scan failure.
Turning the machine's LED lighting on or off.
Viewing and configuring wireless network settings.
Recognizing and cutting files via QR code on USB.
Steps to install the AIDCut-LABEL V5.0.5 machine output plugin.
Choosing between CorelDRAW and Adobe Illustrator plugins.
Inputting the serial number for plugin activation.
Choosing the directory to install the plugin software.
The process of installing the AIDCut-LABEL software.
Handling prompts related to CorelDRAW integration during installation.
Confirmation messages for successful plugin installation.
Confirming the software activation after installation.
Explains the icons used in the CutToolCDR-LABEL-CUTTER plugin.
To Next Page
General