28
If any damage is detected, contact the shipping company or SUNGROW immediately. A rel-
evant photo is preferred. We will provide you with the fast and best service.
Install and commission the PCS only when it is technically faultless! Before instal-
lation, make sure that:
• PCS is intact without any damage;
• All devices inside the PCS are intact without any damages.
4.4 Storage
If it is not to be installed or commissioned immediately upon reception, the PCS should be
stored appropriately.
• The unit must be stored in original packaging with the desiccant inside.
• The PCS must be stored on an even foundation, which must be solid enough to support
the PCS.
• The unit must be stored in a clean and dry place to prevent dust and moisture.
• The storage temperature should be always between -40℃ and +70℃. The storage rela-
tive humidity should be always between 0 and 100% without condensation.
• It is very important to keep the PCS away from harsh environment, for example thermal
shock, cold shock or any collision.
• During the storage time, check periodically (at least once a week) for visible damages by
rodents. Replace the packaging if necessary.
• Unpack and replace the desiccant bag if the PCS has been stored for over half a
year. Repack it after replacement.
• The PCS must be packed!
• No stacking on top of the crate!
• No tilting of the device.
To install the PCS after long-term storage, open the cabinet door and check thor-
oughly to make sure the PCS is intact. Test by professional personnel if necessary
before installation.
4 Delivery User Manual
To Next Page
Loading...
Need help?
General
