sunjoe ASHJ201 - Cleaning the Pre-filter; Support and Troubleshooting; Storage; Service and Support

9
2. Remove the wire lter basket by turning it
counterclockwise. Tap out the basket to remove any
accumulated residue (Figs. 11 – 12).
3. Take out the pleated lter and tap it clean. Remove any
debris with a clean and dry paintbrush or hand brush
(Fig. 13).
NOTE: Do not wash the pleated lter in water.
4. After cleaning, replace the pleated lter on the motor and
lter housing located on the underside of the container lid
(Fig. 14).
NOTE: Check that the rubber rim of the pleated lter is
seated ush against the container lid.
5. Fit the wire lter basket over the pleated lter and turn it
clockwise until it stops. The wire lter basket tabs must
cover and depress the safety stop switch.
NOTE: Make sure the wire lter basket tabs are under the
metal retainer clips.
Cleaning the Air Filter
1. Take o the container cover, wire lter basket and
pleated lter.
2. Take the air lter out of the lter housing (Fig. 15).
3. Clean the lter with soap and water and let it air dry.
4. Place the air lter back into the lter housing and
reassemble the pleated lter and the wire lter basket.
Fig. 11
Wire lter
basket
Fig. 12
Wire lter
basket
Fig. 13
Pleated lter
Fig. 14
0 mm
Fig. 15
Air lter