sunjoe CJ602E - Stand Assembly Fitting; Operation; Starting and Stopping

8
6. Repeat the steps 2 – 4 to assemble the other wheel.
Stand Assembly Fitting
1. Turn the wood chipper + shredder main body upside
down, insert the two ends of the stand assembly into the
housing (Fig. 6).
2. Align the holes on the main body housing and stand
assembly, insert the washer into the screw and install into
the stand assembly on both sides (Fig. 7).
Fitting the Paddle Holder and the Paddle
1. Stand the unit up, and clip the paddle holder to the
standing assembly (Fig. 8).
2. Clip the paddle into the paddle holder (Fig. 9).
NOTE: Be sure to place the paddle in the paddle holder every
time after using.
Operation
Starting + Stopping
mWARNING! Before starting, ensure that the feed inlet
is empty.
mWARNING! The wood chipper + shredder will not run
if the hopper is open or not closed tightly. Always close the
hopper tightly by turning the hopper locking knob clockwise
before starting the machine (Fig. 10).
Fig. 5
Wheel cover
Wheel
Fig. 6
Main body
Stand
assembly
Fig. 7
Washer
Screw
Fig. 8
Paddle holder
Standing
assembly
Fig. 9
Paddle
holder
Paddle