VACUUM TUBE DESIGN IN BOTH THE
PREAMP AND POWER AMPLIFIER
CONSTRUCTED IN AN ALL STEEL
CHASSIS FOR ENDURING RELIABILITY
300 WATTS OF POWER
TWO CHANNELS WITH CLEAN AND
DISTORTION MODES
TRANSFORMER-BALANCED LINE OUT
WITH SPEAKER EMULATION
FOOTSWITCH JACK FOR REMOTE ON-
OFF SWITCHING OF THE GRAPHIC
EQUALIZER, COMPRESSOR AND
CHANNEL SELECTION
LOW-NOISE DIFFERENTIAL EFFECTS
LOOP FOR SIGNAL PROCESSING
DEVICES
SPLIT BAND COMPRESSOR
Congratulations on your purchase of a Sunn
®
300T
Bass Amplifier. Built with care and special attention
to detail, your new Sunn 300T Bass Amplifier offers
much more than meets the eye. Each 300T bass
amplifier is crafted from the finest components
available and assembled at the Sunn amplifier factory
in Corona, California, USA.
The Sunn
®
300T Bass Amplifier includes among its
many features: 300 Watts of power (into 2, 4, or 8Ω);
active compression circuitry and a 10-band graphic
equalizer and high and low frequency controls for full-
bodied tonal shaping. The two channels are voiced
for both clean and distortion outputs offering the
versatility of differing playing styles. The footswitch
circuitry allows for remote selection of the front panel
graphic equalizer, compressor and the channel
selection. Moreover, the rear panel features an effects
loop for the addition of external signal processing
devices or outboard gear, an impedance switch for
different speaker cabinet loads, a tuner out jack for
accessing your tuner and both XLR and 1/4 inch line
out jacks and a pass through jack for routing your
bass signal to another amplifier or mixing console.
In order to thoroughly understand the operation,
features and functions of your new Sunn 300T Bass
Amplifier, please read and refer as needed to this
operation manual. By doing so, your amplifier is sure
to provide you with years of trouble-free music
making and maximum playing enjoyment.
Take the time to get to know each other... Tune-up,
Plug-in and ... Play On!
WARNING:
-TO PREVENT DAMAGE, FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN
OR MOISTURE.
-NO USER SERVICEABLE PARTS INSIDE,
REFER SERVICING TO QUALIFIED PERSONNEL
ONLY.
-ALLOW AT LEAST 3 INCHES (7.6 CM) IN THE
FRONT AND REAR OF THE UNIT FOR PROPER
VENTILATION. DO NOT BLOCK VENTS.
-THIS UNIT MUST BE EARTH GROUNDED.
SUNN 300T BASS AMPLIFIER
3
To Next Page
Loading...
