SUNNEX 81328 - Page 4

For faster action, hot water may be used. If a lower temperature is required, turn the
setting down. For safety reason, when the heating element is over-heated, the safety
thermostat will be cut off. For E01,E07 series units, the Boil-dry Light (red color), on the
right, will light on when no water left in the Water Jacket and Safety Thermostat will be
cut off at the same time, then need to fill water to the Water Jacket.
5.
5
www.sunnex.com.hk
Picture
Description
Part No.
Bain-marie
11388B
Soup Ladle,
only for 87328L,87328P
87328L, 87328, 87328P
72388L
Polycarbonate Cover
Picture
Description
Part No.
Bain-marie
B2442M
E01-1001, E01-1002, E01-1003
Stainless Steel Cover
S2443M0/300
for E01-1003
Picture
Description
Part No.
Bain-marie
83388, 83388L
Stainless Steel Cover
21388L
11388B
Picture
Description
Part No.
E01-1011, E01-1012
Polycarbonate Cover
Bain-marie
B2442M
Soup Ladle,
only for 83388L
Stainless Steel Cover
72389L
 S2443M0 / 200 for
E01-1001 & E01-1002
M411LA
M411LA
Picture
Description
Part No.
Optional Parts
How to Clean / Maintain
Trouble Shooting
81328, 82328L, 82328
Stainless Steel Cover
21388L
Problem 1: Indicating Light is off within 5 minutes after connectinig the power.
Solution 1:Check if no water in the Water Jacket and then fill water.
Problem 2:The unit cannot heat or the water boils.
Solution 2:Contact the local distributors.
4
www.sunnex.com.hk
Bain-marie
11388B
M411LA
Soup Ladle,
only for 81328, 82328L
6. Place the Cover on the Bain-marie for serving.
1. With warm water and mild detergent, clean the Cover, Bain-marie and Soup
Ladle.
2. For Carrie Ring and PP Water Jacket, wipe over with a damp cloth using a
mild detergent .
3. Stainless steel Bain-marie and Cover are dishwasher safe.
4. Heating element ( for E01,E07 series) stuck with dirt will cause malfunction
of the Water Jacket. To maintain an effective performance of the Water
Jacket, the heatingelement should be cleanedat least once in two months.
Fillup the Water Jacket above the heating elementwith half / half distilled
white vinegar (or citric acid) and hot water. Let the heat ingelement soap for a
few hours, then wipeoff  the dirt with a clean cloth. After  cleaning, rinse the
Water Jacket with clean water ( please make sure the water doesn't 
splash into the socket ).
Attention: Do not disassemble Water Jacket and bottom plate of the appliance
 for cleaning.