L2
L1
CT
CT
3. Wire PVS6 power
°
Install a
4. Install consumption CTs
Refer to Section 3 on the other side for complete CT installation instructions.
6. Replace PVS6 wiring covers
5. Wire consumption CTs
7. Connect DC inverter communication
Never run
communication cable and
AC wiring in same conduit
SMA US-40
Inverter
SMA US-22
Inverter
2
7
10. Replace PVS6 cover
8. Connect PVS6 to the internet
Customer’s Wi-Fi
Ethernet Cable
6
9. Commission with PVS Management App
https://www.sunpowerconsole.com
PVS6 Quick Start Guide
Refer to the PVS6 Installation
Instructions on the other side for the complete instructions.
CT
CT
Main Service Panel
PVS6 Connection Diagram: DC Inverter Site
\
DC Inverter
Wire PVS6 power and CTs into
main service panel
Wire communication
from PVS6 to inverter
Wire PVS6 into AC
module subpanel
Wire CTs into main
service panel
AC Module Subpanel
CT
CT
Main Service Panel
PVS6 Connection Diagram: AC Module Site
AC Module Array
From CTs around
service conductors
Load-Side System:
downstream of CTs
Line-Side System:
upstream of CTs
To PVS6
To 15 A or 20 A
dual-pole breaker
Routing wire and cable:
• Fill all conduit openings in the enclosure with
components rated NEMA Type 4 or better
to maintain the integrity of the enclosure’s
environmental system.
•
do not
•
•
•
Note:
Hazardous voltage
DANGER!
SUNPOWER
PVS6
SUNPOWER
PVS6
Remove lower cover rst
2. Remove all PVS6 covers
1. Mount the PVS6
•
•
•
•
•
•
•
•
•
Warning!
To Previous Page
Need help?
General