All In One Heat Pump For Domestic Hot Water
consumed during the process of protecting inner tank and extending use life. Under
some water circumstance, anode rod and water can rise reaction, hot water will be
quickly corroded and rise leakage when anode rod has been used up. We suggest
check insulation materials every one year, if anode rod is used up, you can inquiry
local server center or specific technical department to change a new one;
5. Used for enough hot water where we suggest user turn down setted temperature,
which can reduce heat loss and avoid incrustation, meanwhile this work can help
you save more electric energy and extend use life;
6. Filter should be cleaned up every one month to make sure heating effect;
7. If used for those regions which the temperature is below 0ā, you can take suitable
measures to protect pipes in case the heat pump is installed outdoors for purpose of
protecting connection pipe and keeping your normal life;
II. Error & Approaches
The outlet
water is cold;
The screen
is dark
The plug is not plugged properly.
The temperature controller is on the
lowest temperature control state;
The temperature controller is damaged;
The circuit board of the indicator lamp
is damaged.
Plug in properly.
Set the temperature of the
controller in higher state.
Inform the service man.
No water out
from the hot
water outlet
The tap water is cut off;
The water pressure is too low;
The tap water inlet valve is closed.
Waiting for the restore of the tap
water.
Wait and use when the water
pressure is raised.
Open the tap water inlet valve.
Bad tightness in the connecting points
between pipes.
Improve the tightness of the
connecting points
To Next Page
