A. Preparing for installation:
1.
Remove the seat cushion. Remove the 4 screws (A) holding the seat to the adapter plates or module. Note mounting position on the
adapter plates or module. (Fig 1) Set seat and hardware aside.
2.
Remove adapter plates from the module (if required). Note mounting positon, save hardware. (Fig 1)
3.
Flip the seat frame interface back. Disconnect module harness from base and then remove the 6 screws (B) holding the module to the
seat frame interface. Note mounting position, save hardware. (Fig 2)
A
Adapter
Plates*
Module
Sedeo Ergo
Seat
1
*Sedeo Ergo only
B
Module
Seat Frame
Interface
2
Back
cut-out
ASAP
Seat
Recline
Seat
TILT/LIFT COMBO
HARNESS ROUTING
Please read these instructions carefully before beginning the installation. Failure to understand and
follow installation instructions may result in injury to installer and/or end user and may void the warranty.
If you have any questions call Sunrise Medical Technical support at 800-333-4000.
246792 Rev. A Pg. 1 of 4
©2017 Sunrise Medical (US) LLC
To Next Page
Need help?
General
