SunStar Fortuna 5 Series - Page 28

(D How to use detailed flinctioiis of product counter and bobbin counter
A. How to use the detailed functions of product counter
To use the counter function, set the detailed functions beforehand.
Q To use the product counter function, first set the value of the parameter ||^g[
(group B, item 35) as desired.
• 0: Set the external counter switch on
• 1: Set the automatic counter on after trimming
^ As the default value is set "0", the counter will not run If there Is no external counter
switch.
(2) Set the parameter to sel
• I; Up counter
• 0: Down Counter
^ The default value is set at T.
to select the type of product counter
<The oiirent amount>
(E) Press the counter Q button to set the counter function. Press the button to check and
set the detailed data of the counter.
• Cn: The current counter amount
• m: The remaining amount
• %: The progress
• tn: Total target amount (Default: 100)
^ Press ^ button repeatedly to see the above detailed data in order. The user may
set up the current counter amount (Cn) and the total target amount (tn) as desired.
□1^
<The remaining amount>
inn u^„\
luu llrn
® Affer the total target amount is set, use and to set the movements.
<Set value of B-37>
• 0: When work is fmished, the buzzer will go off and sewing may begin
• 1: When work is finished, the buzzer will go off and sewing may begin only when
the Ql" button is pressed
• 2: When work is finished, the buzzer will not go off and sewing may begin
< Set value of B-38>
• 0: No returning to automatic initial value when counting is complete
• I: Retuming to automatic initial value when counting is complete
<The progress>
"Qiri
<Total taipet amount>
inn iir
lUU lit
[ Caution ]
When B-38 is set at "0', the value will keep on going up/down even when counting is complete. The user will need to re-set tfte
valueofCntoiestarl
From the library of Superior Sewing Machine & Supply LLC - www.supsew.com