SunStar Fortuna 5 Series - Page 65

SunStar
Initial value
INPUTOO (Button A)
INPUT01 (Button B)
INPUT02 (1/4 stitch Swrtch)
INPUT03 (2/4 stitch Switch)
INPUT04 (3/4 stitch Switch)
INPUT05 (4/4 stitch Switch)
INPUT06(Left Sol. Switch)
INPUT07 (Right Sol. Switch)
INPUT10 (Presser Foot-Ufl Switdi)
INPUT11 (Counter Switch)
INPUT12 (P/U1/2 stitch Switch Signal)
INPUT13 (Safety Switch Signal)
INPUT14 (Edge Sensor Signal)
INPUT15 (Thread trimmer not allowed Signal)
INPUT20 (Pedal Start Signal)
INPUT21 (Pedal Presser Foot-Lrft Signal)
INPUT22 (Pedal Trim Signal)
★ B; input PIN function
Actual Hardware Output Name
ButtonASwtch
Button B Switidi
1/4 stitch Switch
2/4 sSth Switch
SWstfch Switch
4/4 stitoh Switch
Left Sd^iotd Switch
Right Solenoid Switch
PtesserFooHjft Switch
Counfer Switch
Ptogiam Unit 12 s6tch Swfeh
Sal^Switoh
Edge Sensor Signal
ThreajTfimmef Signal
RolerLfft Switch
N_AUTO Switch
Pecy Start Sign^
Pedal Presser FooFLift Signal
Pedal Thread Titovning Signal
mm
mm\
jt? Output port changing fundion
- Write the function number
on the output PIN you want
to change after referring to
the table below
Actual Hardware Output Name
ff ivBu&xi A Switch
101 I inv Button B Switch
102 inv 1/4 stitch Switch
103 rv 2/4 stitch Swteh
104 rv 3/4 stitch Swith
inv 4/4 stitch Swith
106 invLdt Solenoid Swteh
107 inv Right SdenoidSwfteh
108 hv Presser FcoHl Switoh
109 rvCourterSwteh
110 inv Program Ur^ 12 Stitch Sv^
111 inv Safety Switch
112 inv Edge Sensor Signal
113 nvTrimmlng Disabled Signal
114 inv Rciier Lit Switch
W inv N AUTO Switch
116 inv Pedal Start Signd
117 inv Pedal Presser FooHit Signal
118 inv Pedal Thread Tttnmng Signal
119 inv External Signal 19' I External Siyal j 119 | inv External Signal
iSThe hardware of input switches and sensors are done with "a point of contact/Active High" input as the standard.
at When setting up other funchons numbers apart from the ones listed above, the pertinent output pin functions are disregarded
A
^Caution: When any inputs PIN No. INPUTOO ~ INPUT22 are overlapped, it works as the "OR" circuit
Ex) if INPUTOO = 0 & INPUT01 = 0. then it is re cognized as "button A" = INPUTOO + INPUT01.
Output Signal Level Collective Reverse Function
Input Signal Level Collective Reverse Function
NOT USED
<lij||Xitsigna Cdlective Reverse, selection
t^nputsignal Cdedive Reverse, selection
If the specific items of the parameter are dianged carelessly, they could break down or damage the mardiine, so the
user must be well-trained before using it.
From the library of Superior Sewing Machine & Supply LLC - www.supsew.com