SunStar Fortuna 5 Series - Page 78

(4) Thread Trimming Sequence Program Code List
Category
Output
Port
Control
Time Way
Explanation
Cmd Field
B/T Solenoid On
81H
P/F Solenoid On 82H
T/T Solenoid
On
83H
W/P Solenoid On 84H
T/R Solenoid On 85H
Left Solenoid On 86H
Right Solenoid
On
87H
AUX Sdenoid On 88H
Left LED On 89H
Right LED On 8AH
Needle Up Signal On 8BH
Needle Down Signal On 8CH
Motor Runing Signal On 8DH
Reaching Target Speed Signal On 8EH
Motor Trimming Signal On 8FH
Motor End Tacking Signal On 90H
Emergency Stop Signal On 91H
Roller Lift Solenoid On
92H
Hemming Device Output On 93H
Pedal Forward Step1 Signal On 94H
B/T Solenoid Off 98H
P/F Solendd Off 99H
T/T Solenoid
Off
9AH
W/P Solenoid Off 9BH
T/R Solenoid
Off 9CH
Left Solenoid
Off 9DH
Right Solenoid Off 9EH
AUX Solenoid Off 9FH
Left LED
Off AOH
Right LED Off A1H
Needle Up Signal
Off
A2H
Needle Down Signal Off A3H
Motor Runing Signal
Off A4H
Reaching Target Speed Signal
Off ASH
MotorTrimming Signal
Off A6H
Motor End Tacking Signal
Off A7H
Emergency Stop Signal
Off ASH
Roller Lift Solenoid
Off
A9H
Hemming Device Cutout
Off AAH
Pedal Forward Step1 Signal
Off ABB
Delay by 1[ms] unit BOH
Delay by 2[ms] unit
B1H
Delay by 4[ms] unit
B2H
Delay by 0.5[s] unit
B3H
Data Re
2nd
0-255[ms]
(1ms)
0-510[ms]
(2ms)
CM020[ms]
(4msl
From the library of Superior Sewing Machine & Supply LLC - www.supsew.com