29
B. Adjusting movable and fixed knife (See figure 47)
a) Like in figure 47, adjust the position of the fixed knife ③ so that the fixed knife right side edge② matches the
movable knife inner side edge①.
b) The initial assembling position of the movable knife ④ is where the movable knife-edge protrudes about 3 mm
from the edge of the fixed blade. Please check the “final fixing of the movable knife initial position”on page 30.
c) The surface adhesion conditions ⑤ of fixed blade edge and movable knife upper side have huge impact on its
trimming capacity. Please note the various cases of movable/fixed knife surface adhesion conditions on the
picture.
[Correcting the adhesive conditions of movable and fixed knives]
※ Like in figure 47, operate manual trimming movement with magic ink on the movable knife-edge. By checking
the ink trace remaining on the movable knife, the surface adhesion condition of the movable/fixed knives can be
tested.
※ If the surface adhesion is not very good (same method is used to adjust the tension of movable/fixed knives),
please use the following methods: adjusting the amount and position of the washer ⑦ in the lower side of the
movable knife base ⑥, horizontally adjusting the assembling position of movable knife shaft collar ⑧, and
correcting the shape of fixed blade ⑨ setting position.
[Figure 47]
[Checking the surface
adhesion]
(good)
(bad)
(bad)
※ Apply magic ink on the
upper side of the movable
knife-edge
To Next Page
Loading...
