12
5) Installation of belt cover
Fix belt cover “A” ① onto the machine body with using three
clamp screws ②. Lay the machine back and it will be easy to
assemble belt cover “A” ①. After the assembling, insert the
front part of belt cover “B” ③ into the groove of belt cover
“A” ① and then fasten the back part of it by using the clamp
screw ④.
[Figure 5]
4) Adjustment of belt tension
After installing the motor, loosen the fixing nuts ①, ② up and
down and tension will be created to the belt ④ due to motor ③
falling by gravity. Fasten the fixing nut ① initially and then
fasten the fixing nut ② tightly.
[Figure 4]
To Next Page
Loading...
