17
7) Rotating roller shaft
A. Raise the presser bar lifter.
B. Hold the roller presser foot bracket guide ① as in Figure 17
and move it down and left. Then, there will be some space
to exchange the gauge.
C. To restart, hold the roller presser foot bracket guide ① and
turn it to the right direction.
[Figure 17]
8) Adjusting stitch length
As in Figure 18, the number marked in the stitch length
adjusting dial① indicates the stitch width by mm. By moving
left or right, set to the desired number.
[Figure 18]
①
To Next Page
Loading...
